Foxeer FPV Video Scrambler Analog Zero-Latency Kit (Scrambler + Descrambler) 5V / 5-36V

Overview

Foxeer FPV Video Scrambler is an analog, zero-latency video scrambling/descrambling solution designed for FPV video links. Note: this device can not work with the monitor/VRx with 7456E OSD chip.

Key Features

• Analog signal support
• Zero latency
• Two-part solution: scrambling board (TX side) and descrambling board (RX side)

Connections / Pin Labels (from wiring diagram)

• Scrambling board labels: VIDEO, GND, 5V OUT, TRAMP, GND, 7-36V OUT
• Camera plug labels shown: VSEN, OSD, VID, GND, VCC
• Receiver/monitor side labels shown: BAT+, GND, VIDEO

For installation assistance and compatibility questions, contact https://rcdrone.top/ or [email protected].

Specifications

Whats Included

• Scrambling: 1 x Scrambling Board
• Scrambling: 2 x SH 1.0-6pin Cable
• Descrambling: 1 x Descrambling Board
• Descrambling: PH 1.25-3pin

Diagram

Details

The Foxeer FPV video scrambler wiring uses labeled VIDEO, GND, 5V IN/OUT, TRAMP, and 736V OUT pads for connecting camera, flight controller, and VTX/receiver.